How to Keep Maintain Your Garage Door Springs

Garage door springs need proper care and maintenance because they are one of the most important parts of your garage door. When they break or loosen, it can be very dangerous for both you and anyone else in or around your garage. It is also not cheap to replace them.

If your springs do fail, it’s best to contact Santee garage door springs repair service to solve the problem as soon as possible. This article will go over how you can keep maintaining your garage springs so that they last longer before breaking.

How can I make my garage door springs last longer?

The answer to this question is simple – in order to prevent potential safety hazards you just have to maintain them. If you don’t take the time and care to make sure that they are properly lubricated, adjusted, tuned, or installed then your springs will begin to break down over time

That means more work for you in order to change them out when they inevitably snap, because you can’t fix broken garage door springs. However, if done correctly, proper maintenance can save a lot of money in the long run by preventing any other potential issues from arising during use.

There are three types of garage door springs:

  • Torsion spring systems – This is one of the most common types of garage door springs. When adjusting these springs be sure to make any adjustments in small increments, because big adjustments can cause damage to the cable drums which could end up damaging other parts on the door.

It is also important to note that when installing torsion springs, there should always be enough remaining coils so that it does not drop below the height of tracks (to avoid pinching).

  • Extension spring systems – Extension springs break down over time unless periodically treated in some way, such as by being sprayed with graphite powder or silicone spray. However, this is most effective on newer doors and less of a concern on older ones where the spring has already begun to break down.

When it comes to lubricating these springs you should start by pulling the door up and out with a cord or rope, then spray on the graphite powder or silicone spray, follow that by spraying some oil into the spring coils at each end of every inch while slowly releasing tension until completely unloaded.

  • Chain-drive double-track systems – This system may need special attention when being maintained as they typically have two torsion bar drums running in opposite directions and if not properly lubricated then it is likely that one or both of these will snap.

When maintaining this type of system, be sure to use a graphite powder spray as silicone may not work well with the metal chains and drums. To do maintenance, follow instructions closely and make any adjustments in small increments as too large a change can cause damage to cables or other components over time.

Can a garage door work without springs?

Most garage doors have some sort of an emergency opening mechanism that enables users to manually open them in case of a spring malfunction or a power outage. However, this should only be done when there’s no other option, and any spring malfunctions should be fixed by a registered technician as soon as possible. 

Garage door springs contain an immense amount of energy, so you should never attempt a DIY fix unless you’re a trained and experienced garage door technician yourself.

Who provides the most reliable Santee garage door springs repair service?

When your car needs maintenance, you call an expert. It should be the same when it comes to your garage door! Make sure that your garage door in San Diego performs smoothly by having it regularly serviced by the experienced technicians at Dlouhy Doors. 

Our experienced team will provide you with free on-site estimates to meet all your garage door installation, repair, or maintenance needs. Get in touch with us today and take a relaxing stroll through Big Rock Park while our expert technicians deal with any garage door-related issue you may have.